Sanyo DC-TS3000 Service Manual page 13

DISASSEMBLY INSTRUCTION
NOTE
1. After the assembly of the Rack Feed, check if the Rack
Feed 1/2 is moving smoothly. (Refer to Fig. 3-7-B)
2. In case of the Rack Feed Ass'y installation, install
correctly as Fig. 3-7-C.
Moving smoothly
Moving smoothly
Check the position of
the Rack Feed Lever.
3-8: RELAY PCB ASS'Y (Refer to Fig. 3-8-A)
1. Remove the screw .
1
2. Remove the Relay PCB Ass'y.
Relay PCB Ass'y
NOTE
1. When installing the wire of the Relay PCB, install it
correctly as Fig. 3-8-B.
Fig. 3-7-B
Should not be engaged.
Fig. 3-7-C
Main Chassis Ass'y
1
Fig. 3-8-A
Fig. 3-8-B
3-9: GEAR (Refer to Fig. 3-9-A)
1. Unlock the support
2. Remove the Middle Gear 1/2/3, Idler Gear and Feed
Gear.
Middle Gear 2
Middle Gear 3
Idler Gear
Main Chassis Ass'y
NOTE
1. In case of the Idler Gear installation, install correctly as
Fig. 3-9-B.
2. When installing the Middle Gear 2, check if the Middle
Gear 2 is locked correctly as Fig. 3-9-C.
[OK]
Idler Gear
Idler Arm
3-10: IDLER ARM (Refer to Fig. 3-10-A)
1. Remove the Idler Arm Spring.
2. Remove the Chassis Spring.
3. Remove the Idler Arm.
Idler Arm Spring
Main Chassis Ass'y
- 12 -
.
1
Middle Gear 1
Feed Gear
1
Fig. 3-9-A
[NG]
Idler Gear
Idler Arm
Fig. 3-9-B
Check Lock
Middle Gear 2
Fig. 3-9-C
Idler Arm
Chassis Spring
Fig. 3-10-A