Samsung VS20R90 Series User Manual page 16

Installing the charging stand
Installation guide
'Click'
1
3
2
1
3
60 cm 66 cm
❇ ❇ Please refer to the QR code for detailed information on the installation and
charging method of the charging stand.
1_VS9000_EN_00821R-00_AP_A5.indd 15
2
4
4
Assembling the charging stand
1 Assemble the stand pipe to the bottom
support, and fix it with a screw (small).
– Make sure the direction for the assembly
is correct and push it in firmly so that the
screw hole is made correctly.
2 Assemble the vacuum charging part to the
top of the stand pipe.
– Do not disassemble it after the assembly.
3 Connect the power cord to the rear of the
charging stand.
– Hold the connection part of the cord and
push it onto the connection pins firmly
until the gray lines on the tip of the cord
are not visible.
– When inserting the cord into the groove
on the bottom of the bottom support,
charging stand can be installed close
against the wall.
4 Plug in the charging stand.
Fixing by the hook
1 Using the fixing hook as a template, mark
where the top and bottom screw holes will
be placed on the wall.
– Top: 66 cm from the floor
– Bottom: 60 cm from the floor
2 Drill the holes using a 6 mm drill bit, and
put the provided screw anchors into the
hole.
3 Fix the fixing hook to the wall with the
provided screws (large).
4 Hook the groove of the charging stand into
the fixing hook.
English 15
2020-05-25 오후 3:03:59