Moving A Non-Functioning Machine - Toro GrandStand Revolution TURBO FORCE 18560 Operator's Manual

•
Do not operate the charger with a damaged cord
or plug. Contact an Authorized Service Dealer to
obtain a replacement cord.
•
If the charger has received an impact, been
dropped, or otherwise damaged, do not use it;
take it to an Authorized Service Dealer.
Moving a Non-Functioning
Machine
Important:
Do not tow the machine without first
disengaging the transmission, otherwise you
could damage motor components.
CAUTION
The machine does not have brakes when
the transmission is disengaged. It will roll
uncontrolled, possibly causing injury.
If you must tow the machine, install the Tow
Bar Assembly Kit to prevent the machine from
colliding with the towing vehicle. Contact
your Authorized Service Dealer to obtain the
kit.
1. Disengage the PTO and move the motion-control
levers outward to the P
2. Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the cap from the motor.
1. Motor cap
position.
ARK
Figure 34
4. Insert a ratchet with a 3/8 inch drive into
the square hole in the motor hub. Rotate it
counterclockwise until it stops (approximately
4 full rotations) to disengage the transmission.
Torque to 41 to 68 N∙m (30 to 50 ft-lb).
Note:
The wheel will spin freely.
5. Repeat for the other motor.
6. Move the machine to the desired location.
Important:
than 8 km/h (5 mph).
7. Immediately after moving the machine, engage
the transmission for operation.
A. Insert a ratchet with a 3/8 inch drive into the
square hole in the motor hub.
B. Rotate it clockwise until it stops
(approximately 4 full rotations).
C. Torque to 41 to 68 N∙m (30 to 50 ft-lb).
g377043
26
Figure 35
Do not move the machine faster
Figure 36
g377045
g377042