Recommended Maintenance Schedule; Pre-Maintenance Procedures; Moving A Non-Functioning Machine - Toro eTimeCutter 75841 Operator's Manual

Recommended Maintenance Schedule

Maintenance
Service Interval
After the first 50
hours
Before each use or
daily
After each use
Every 25 hours
Yearly
Before storage

Pre-Maintenance Procedures

Moving a Non-Functioning Machine

1. Park the machine on a level surface and disengage the blade-control switch (PTO).
2. Shut off the machine and remove the key.
3. Remove the battery packs from the machine.
4. Ensure that the parking brake is disengaged.
The machine could unintentionally move while the parking brake is disengaged and
injure you or bystanders.
Engage the parking brake after moving the machine.
5. Push the machine as required.
Always push the machine at a slow walking speed; do not tow. Moving the machine at
a faster speed may damage it.
If the display powers on while you push the machine, move the machine at a slower
speed.
6. Engage the parking brake.
Maintenance: Recommended Maintenance Schedule
Maintenance Procedure
Check the lug-nut torque.
Check the safety-interlock system.
Inspect the blades.
Inspect the grass deflector for damage.
Clean grass and debris from the machine.
Check the tire pressure.
Check the battery box
Check the lug-nut torque.
Perform all maintenance procedures listed above before storage.
Paint any chipped surfaces.
filter; replace as needed.
WARNING
IMPORTANT
Page 5–2 3463-565 A