Adjusting The Height-Of-Cut; Adjusting The Slope Of The Mower Deck - Toro GrandStand Revolution TURBO FORCE 18560 Operator's Manual

Adjusting the Height-of-Cut

The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Figure 29
Adjusting the Slope of the
Mower Deck
You can raise the rear of the mower deck in 6.3 mm
(1/4 inch) increments, up to 31.8 mm (1-1/2 inch).
1. Disengage the PTO and move the motion-control
levers outward to the P
2. Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the height-of-cut lever and lock it into the
transport position.
4. On the left or right side of the machine, raise the
lever and remove the pin.
5. Install the pin at the desired position.
g330789
6. Repeat the procedure for the other side of the
machine.
23
position.
ARK
Figure 30
Figure 31
g377014
g377012