Troubleshooting; Technical Specifications - Bosch 1 687 023 777 User Reference

3.

Troubleshooting

3.1 LED status display of the Bluetooth
USB adapter
LED Status
Off Not recognized, standby or defective
Flashing Communication possible
3.2 Bluetooth symbols in the task bar
R
The Bluetooth manager symbol
task bar when the Microsoft Bluetooth driver is
activated.
R
The Bluetooth device symbol
in the task bar when there is an active Bluetooth
wireless link between a PC/laptop and a wireless
system.
i
Display of multiple Bluetooth device symbols
is possible, depending on the number of active
wireless systems.
i
When a KTS 560 / 590 is being used, the Bluetooth
device symbol usually is not displayed.
3.3 Bluetooth USB adapter is not
recognized
Possible causes What to do
No Bluetooth USB Plug in Bluetooth USB adapter.
adapter.
The Bluetooth 1. Deactivate the Bluetooth hardware
hardware installed in installed in the PC/laptop (see
the PC/laptop is not sec. 2.2).
deactivated. 2. Reboot PC/laptop.
Robert Bosch GmbH
Possible causes
USB interface is
defective, or Windows
did not recognize
Bluetooth USB adapter.
3.4
Possible causes
appears in the No voltage supply to
the wireless system.
Wireless system (e. g.
BEA 030, BEA 060,
is also displayed
BEA 070) not active or
incorrectly configured
Wireless system
(KTS module) not
active or incorrectly
configured
No Bluetooth wireless
link (e.g. after standby
mode of the PC/
laptop).
4.
Please find the technical data on the last but one page
of these instructions.
| 1 687 023 777 | 9
What to do
1. Unplug Bluetooth USB adapter and
plug into another USB interface.
2. Reboot PC/laptop.
No communication or Bluetooth
wireless link is interrupted
What to do
Test the voltage supply.
1. Start CDC:
"Start >> All Programs >> Bosch >>
Diagnostics >> Central Device Com-
munication" or left-click " " in the
task bar.
2. Test the connection type in CDC:
"Settings >> Device interfaces", test
connection: USB/BTB (Bluetooth).
1. Start the DDC.
2. In DDC check whether the KTS
module has been correctly config-
ured and activated.
3. Finally, test the KTS module.
R Reduce distance between Bluetooth
USB adapter and Bosch product.
R When setting up the PC/laptop
with Bluetooth USB adapter, make
sure there are as few obstacles
as possible (e.g. steel doors
and concrete walls) which could
interfere with the wireless signal
from and to the Bosch product.
R Unplug the Bluetooth USB adapter
and plug it in again or re-boot the
PC/laptop.

Technical specifications

1 689 989 277
en
|
2019-02-08