Suggestions For Corrective Action - HP Vectra VT6 Technical Reference Manual

8x03, 8x04
8050
8060
8400
9000..900F
9010
9100..910F
9200..910F
A001
A002, A00C
B300
B320
E000..EFFF.

SUGGESTIONS FOR CORRECTIVE ACTION

An exhaustive list of the suggestions for corrective action (SCA) is given here, to accompany the
list of the error codes that is given in the previous section. In order to find the suggested corrective
action, it is necessary to read the five-character code that is given on the right of the error code in
the previous section. This SCA code can then be found in the list in this section. These have been
sorted into numerical order, to make it easy to find the appropriate entry.
SCA01
• Your system board may need to be replaced. Contact your service representative.
SCA02
1 Remove or disable the ROM(s) on the accessory board one by one to determine which
one, if any, has failed.
2 If this fails to correct the problem, your system board may need to be replaced. Contact
your service representative.
SCA03
• For models without a battery, this problem may occur if the PC is left unplugged for
periods of 24 hours or more.
• For models with battery, replace the battery.
Run Setup to correct the date and time information.
1
2 If after running Setup the problem re-occurs even after a RESET or [CTRL] [ALT]
[DELETE], ensure that the CONFG switch on the system board is set to Off.
3 If all the above fail, your system board may need to be replaced. Contact your
service representative.
SCA04
Run Setup to correct the configuration information.
1
2 If after running Setup the problem re-occurs even after a RESET or [CTRL] [ALT]
[DELETE], ensure that the CONFG switch on the system board is set to Off.
3 If all the above fail, your system board may need to be replaced. Contact your service
representative.
Setup 's custom-configured hard disk drive information is
incorrect.
The built-in hard disk controller's address is used by a hard disk
controller on an accessory board.
The system has detected that one or several IDE hard disks were
added or removed since the PC was previously started (booted).
The hard disk drive's boot sector has been corrupted.
Flexible disk drive A, its cable, or the controller has failed.
The built-in flexible disk controller's address is used by a flexible
disk controller on an accessory board.
The second flexible disk drive, its cable, or the controller has
failed.
The third flexible disk drive, its cable, or the controller has failed.
Setup 's co-processor information does not match the hardware
installed in the computer.
The co-processor has failed.
The memory cache has failed.
The memory cache module has failed.
The RAM on an accessory board has failed.
SCA05
SCA19
SCA18
SCA20
SCA17
SCA19
SCA17
SCA17
SCA05
SCA22
SCA01
SCA28
SCA15