Physical Characteristics; Electrical Specification - HP Vectra VT6 Technical Reference Manual

PHYSICAL CHARACTERISTICS

System Processing Unit
Weight:
Dimensions:
Footprint:
Keyboard:

ELECTRICAL SPECIFICATION

Parameter
Input voltage
Input current (max)
Input power (max)
Input frequency
Heat dissipation
Available power
Max current at +12 V
Max current at -12 V
Max current at +3.3 V
Max current at +5V
Max current at -5V
Max current at +5Vst
*Since 29 A at 5 V equates to 145 W, it follows that for every 1 A that is required from the 3.3V
supply, it is necessasry to reduce the 29 A limit on the 5 V supply by 0.66 A. For example, 3A
at 3.3 V plus a maximum of 27 A at 5 V, or 6 A at 3.3 V plus a maximum of 25 A at 5 V.
An attempt to draw too much current (such as a short circuit across edge-connector pins, or an
accessory board that is not suitable for these PCs), will cause the overload protection in the power
supply to be triggered, and the PC could fail to boot.
33 lbs (15 kg)
15.95 inches (D) by 8.27 inches (W) by 16.34 inches (H)
(40.5 cm by 21 cm by 41.5 cm)
0.91 sq ft (0.085 m 2 )
18 inches (W) by 7 inches (D) by 1.3 inches (H), when flat, or
18 inches (W) by 7 inches (D) by 2 inches (H), when standing
(464mm by 178mm by 33mm when flat, or
464mm by 178mm by 51mm, when standing)
Total Rating
100-127 200-240
Vac Vac
6 A 3.15 A
280 W
47 Hz to 63 Hz
280 W
200 W
4 A
0.5 A
16 A
29 A
0.2 A
70 mA
Typical per PCI
Notes Accessory Slot
Switch selectable
Less than 5 W
when turned off
15 W (max)
— 0.2 A
— 0.2 A
Together, these two These must not
must not exceed exceed 2.5 A
145 W* per slot
— —
— —
Typical per ISA
Accessory Slot
15 W (max)
0.2 A
0.5 A
—
1 A
0.2 A
—