Vli 8Sf Models - HP Vectra VLi8 Technical Reference Manual

Connectors
Adding a Network
Accessory Board
NOTE
2 System Features
Network

VLi 8SF Models

On HP Vectra VLi 8SF PC models, the network solution is integrated; the
3COM chip is built into the backplane (refer to backplane diagram on page
22 for its location).
The 10/100BT connector and a network activity indicator are located on the
rear panel of the PC.
When connected, the activity indicator glows constantly. The indicator will
blink to indicate network activity.
There is no Wake On LAN (WOL) connector.
The integrated network can be disabled in the
program, if a network accessory board is installed. However, as there is no
Wake On LAN (WOL) connector, this feature is lost when a network
accessory board is installed.
A 3COM LAN Boot ROM is integrated in the BIOS ROM chip on the system
board. As a result, it is not necessary to insert a Boot ROM chip into the LAN
card to perform a Remote Boot.
For more information on network technology, refer to the Technical
Reference Manual - Vectra Technology.
38
menu of the Setup
Advanced