Replacing The Fuse; Temperature Setting - VECTECH 966D Instruction Manual

larger sponge above it wet at all times.
3. The large sponge may be used alone without small sponge and water.
Dampen the large cleaning sponge and place it on the iron holder base.
4.2 Connecting
Caution:
Be sure to turn off the power switch before connecting or
disconnecting the soldering iron. Failure to do so may damage
the soldering station.
1. Connect the plug of Handle Cord Assembly to the receptacle in front of unit.
2. Place the Soldering Iron in the iron holder.
3. Put the power plug into 3-terminal grounded socket with rated voltage.
4. Connect the terminal of grounding cord to grounding socket and the other is
connected to earth.
5. Turn on power switch.

4.3 Temperature Setting

Caution:
 Make sure the temperature of the station can be adjusted (the inputted
password is right or the password is initial). Or else, the temperature
cannot be changed.
 If you turn off the power switch during the temperature setting, setting
value will not be stored in the memory.
While setting the temperature, the heating element is off. UP and DOWN
Page 4
2. Check the resistance between the pin of the plug and the wire on the terminal.
Pin 1: Blue
Pin3: Green
Pin5: Black
The value should be 0Ω. If it is greater than 0Ωor is ∞, the cord should
be replaced.

10.3 Replacing the fuse

1. Unplug the power cord form the power receptacle.
2. Remove the fuse holder and then take out the broken fuse.
3. Replace the fuse. Put the fuse holder back in place.
Pin4: White
Pin6: Red
Page 13