HP Vectra VE5 2 Supplementary Manual page 22

2 pc

Hide thumbs Also See for Vectra VE5 2:

Table of Contents

To install the upgrade processor and VRM:

Remove the old processor and heatsink. Insert the new processor into the processor

socket, making sure that the dot or notch on the processor is aligned with the dot on the

socket . If the new processor has a detachable heatsink, secure the heatsink onto the

processor with the clip provided.

Remove the old VRM by unclipping the two white tabs and sliding it up and out of the

socket.

Insert the new VRM. Slide the module into the socket, pressing it down firmly, then push

the two white tabs back into place. The VRM module goes in one way only .

Set switches 1,2,3,4, and 7 on the system board for the correct processor speed. Refer to

the section "System Board Switches," in chapter 2.

Note that you will not need to change these switches if the new processor is an Intel

Overdrive for the old Intel Pentium processor.

WARNING:

Processor, VRM and 3.3V connector

The speed selected by the system board

switches must correspond to the speed of the

installed processor.

Table of Contents

Vectra ve 5/xxx - 2 Vectra ve 5/xx series