Permobil Comfort M2 Operation Manual page 6

Comfort Cushions - M2, Acta-Embrace, Curve Operation Manual
PARTS DETAIL
Package contents: cushion, covering(s)*, operation manual
M2
(Anti-thrust)
The serial number label is located on the bottom of
the cushion.
See the product specifications section in this manual
for information about cover materials.
To order replacement parts, contact your equipment
provider or Customer Support.
CUSHION PLACEMENT
WARNINGS:
- Risk of falling: The bottom of the Incontinence Liner is slippery; DO NOT
use the Incontinence Liner without a cover.
- The cushion must be used with compatible covering(s).
- Inspect the cover and the foam for damage, and replace if necessary.
- When possible, use the loop fasteners to further secure the cushion to
the seating surface.
1 Place the cushion on the seat.
2 Before sitting on the cushion,
check the orientation: Refer to the
directional patch and make sure that
the zipper is in the back. For Embrace
and M2 cushions, the carrying handle
should be in the front.
3 The user should sit on the cushion, in
their usual sitting position.
Make sure that the cushion is
properly sized to the individual.
IMPORTANT! If using an ATI (Adjustable Technology Insert for
Positioning) with the M2 Cushion or the Acta-Embrace Cushion, place the
ATI inside the cover and beneath the cushion (and beneath the
Incontinence Liner, if using). Refer to the ATI instructions for placement
and adjustment.
Acta-Embrace
(Anti-thrust)
4
Curve
*Coverings available:
- Stretch-Air (shown) available on all cushions.
- Comfort-Tek available with Curve or as an
accessory for M2 and Acta-Embrace.
- Incontinence Liner available as an accessory
for all cushions.
Cushion with Cover: Orientation
Zipper
in Back
Directional Patch: The seated figure
shows product orientation.
Incontinence Liner
Front