Aeros COMBAT-09 Owner's Service Manual page 8

6. Attach the ring of the bottom front wires to the hook on the bottom nose plate
7. Turn the hang point spreader bar perpendicular to the keel tube
Close the central access zipper.
Fix the Velcro straps behind the
hang loop.(Fig.8)
8. Remove the battens from the batten bag, and check each batten for symmetry against the corresponding batten
from the other wing. Align the battens at the nose, and at about the 60% chord point as shown. There should not be any
deviation of more than 3mm (1/8'') from one batten to the other along the full length of the battens.
Aeros convention is that green (blue) marked battens go in the right wing and red marked battens in the left.
Battens are numbered from the center outwards, and the longest batten in a Combat is designated as the "# 1"
batten.
Install the cambered top surface battens in the sail, leaving out the shortest four on each side for now.
Install the lever batten tips into the hem of the trailing
edge. At each batten, make sure the opening in the
underside of the trailing edge hem is spread to accept the
tab on the batten tip. Make sure the tab slides fully into the
hem
(Fig.9).
Fig. 6
(Fig.7).
7
(Fig.6).
Fig. 7
Fig. 8
Fig. 9