Table of Contents
Advertisement
APPENDIX A- AC POWER, POWER CORD, AND FUSE ACCESS
1.
AC Power and Power Cord
The Lavry Savitr AD-24-200 power supply accepts AC power in the range of 90-264 Volts at 47-63
Hertz. The power supply adjusts automatically for proper operation with AC power within this
voltage & frequency range.
The power for the Savitr is controlled by the rear panel power switch.
The included power cord has a push-button locking feature. Once inserted, you must press the
yellow button to remove the power cable!
2.
Accessing the Fuses
The Savitr has two fuses located in the Power Entry Module (PEM).
The following procedure will provide the information needed to access the fuses in your Savitr.
The AC power cord must be removed before attempting to access the fuses!
The Savitr requires two 1.25A Time Delay (Slow Blow) 250V 5mm x 20mm fuses. They are located in
fuse tray
the
of the PEM.
The fuse tray is held in the PEM by two small spring-loaded plastic tabs, which must be pressed
with a small screwdriver to release. The top tab must be pressed downward and the bottom tab
must be pressed upward. If possible, use two small screwdrivers to press both tabs at the same
time.
Here is an illustration of the rear panel:
Always replace the fuses with the recommended type and use the same value for both fuses!
If you have any questions, please contact us at:
techsupport@lavryengineering.com
14
Advertisement
Table of Contents
