Commissioning And Menu Navigation; Manual; Daily Timer - Orca UVpro V-LAB Operating Instruction

Commissioning and menu navigation

In addition to the following instructions, fig. 1 visually depicts the menu navigation of the V-LAB.
After plugging in the device plug, the V-LAB is in stand-by mode. Press the enter button to switch on the
unit. The display lights up and you can see the main menu (see fig. 1, blue frame). It consists of these four
menu items: 1. start menu, 2. system service, 3. date/time, 4. operating mode. Navigate through the menu
with the arrow buttons to change settings.
Press the enter button to choose the respective item and to open the submenu. To exit the chosen menu,
press the escape button.
1. Start menu
The start menu shows the device name, the time, the operating status and the set intensity. In the lower left
corner, you can see the set operating mode: Manual (Man), Timer Daily (D-Timer) or Timer Weekly (W-Timer).
In the mode Manual, the sterilisation and ventilation can be started by pressing the enter button and stopped
by pressing escape.
2. System service
Under the menu item system service, you can enter the system menu by pressing the enter button for 3
seconds to see and change basic settings of the system. You'll find details about the software version, the
reset to the factory settings, operating hours of the tubes, language options and the alert threshold for
detecting tube failures.
3. Date/time
The third menu item date/time leads you to the subitems "set time" and "set date" by pressing the enter
button for 3 seconds. Select the respective subitem and set the time by pressing the arrow buttons and press
enter to confirm. Under "set date" you can select and confirm the day and date in the same way.
4. Operating mode
Choose between manual, daily timer and weekly timer under the fourth menu item.
The sterilisation can be started and stopped manually in the mode „manual". The mode "daily timer" enables
to set four daily repeating sterilisation times and under "weekly timer" it is possible to make day- and week-
specific settings regarding the sterilisation period. Please find the detailed descriptions of these modes below.

Manual

In this mode, the sterilisation and ventilation can be started by pressing the enter button and stopped by
pressing escape. By scrolling further through the menu, you will reach the menu item "ventilation" to set the
intensity between 0% and 100%.

Daily timer

This menu item allows you to set four different daytimes and intensities of the ventilation to sterilise the air.
Navigate to the end of the main menu and select one of them, e.g. D1. Now you can activate (on) or deactivate
(off) it, set the starting time, the intensity, and the finishing time of the sterilisation. To confirm these settings,
press enter. Four different settings (D1-D4) can be made per day that will repeat automatically every day
orca GmbH www.uvpro.de
Recirculating Air Disinfection System V-lab
Seite 19 von 28