To Remove The Pipe Port Cover; Connecting The Drain Piping; General Guidelines; To Connect The Piping On Right Side, Right-Back, Or Right-Bottom - Daikin CTXA15A2V1BW Installer's Reference Manual

6.3.3 To remove the pipe port cover

6.4 Connecting the drain piping

In this chapter

6.4.1 General guidelines

CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
4P518023-3K – 2022.05
INFORMATION
To connect the piping on right-side, right-bottom, left-side or left-bottom, the pipe
port cover MUST be removed.
1 Cut off the pipe port cover from inside the front grille using a coping saw.
2 Remove any burrs along the cut section using a half round needle file.
NOTICE
Do NOT use nippers to remove the pipe port cover, as this would damage the front
grille.
6.4.1

General guidelines..................................................................................................................................................

6.4.2

To connect the piping on right side, right-back, or right-bottom.........................................................................

6.4.3

To connect the piping on left side, left-back, or left-bottom................................................................................

6.4.4

To check for water leaks ........................................................................................................................................

▪ Pipe length. Keep drain piping as short as possible.
▪ Pipe size. If drain hose extension or embedded drain piping is required, use
appropriate parts that match the hose front end.
NOTICE
▪
Install the drain hose with a downward slope.
▪
Traps are NOT permitted.
▪
Do NOT put the end of the hose in water.
6 Unit installation
|
29
30
31
32
Installer reference guide
29