Canon imageRUNNER ADVANCE C9270 PRO Basic Operation Manual page 92

• When loading paper into the paper deck for the fi rst time, adjust the size change plate to match the paper size being loaded.
(See "Changing the Paper Size for the Multi-drawer Paper Deck-A1, " on p. 93.)
• When loading paper into the paper deck, make sure that the paper size setting is the same size of the paper that is being
loaded.
• Load the paper below the rollers of the paper holder.
• When loading paper, make sure that the height of the paper stack does not exceed 13/16" (20 mm). If the height of the paper
stack exceeds 13/16" (20 mm), the edges of the paper stack may become curled or creased, and poor print quality may result.
• For instructions on loading tab paper into the paper deck, see "Loading Paper, " on p. 66.
• For instructions on loading transparencies, see "Loading Transparencies, " on p. 72.
• If there are instructions on the paper package about which side of the paper to load, follow those instructions.
• When paper is loaded in the Multi-drawer Paper Deck-A1, the side facing up is the one printed on.
• If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reloading it. However, textured
paper, single-sided coated paper, and paper already printed on cannot be turned over. Change to new paper.
• For more information on the print direction of preprinted paper (paper which has logos or patterns already printed on it), see
e-Manual > Copy.
• Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
• If paper runs out and printing is stopped, load a new paper stack. Printing restarts after the new paper stack is loaded.
92