Table of Contents
Advertisement
2. Telnet
Some functions of the IPStecker is available via Telnet. If a password was set to access the
device, it will be also required to establish a Telnet connection. To access the IPStecker this
way, create a command prompt: type in Start menu / Run window "cmd"; in case of Windows
98: command; and enter OK. Into the appearing textbox type in "telnet (IP address of the
device)"
Accessing the plugs, modifying connection settings and changing password are also
available via Telnet. The password set this way is the same to reach the web interface.
Advertisement
Table of Contents
