Connecting Speakers Using The Creative Sound Blaster X-Fi Sound Card; Connecting The Speakers - HP Media Center,Pavilion Media Center m7780 Start Here Manual

Connecting Speakers Using the Creative Sound
Blaster X-Fi Sound Card
36
Start Here
This section provides an overview of connecting to the Creative Sound Blaster X-Fi
sound card.
NOTE: For additional information on connecting the speakers, refer to the documentation
that came with your speakers.

Connecting the speakers

Connector Description
AD-Link for AD_Link X-Fi I/O Console (the X-Fi console is sold separately)
Line Out_3 (orange or yellow)
5.1 audio setup: Front center, subwoofer
6.1 audio setup: Front center, subwoofer, and rear center
7.1 audio setup: Front center, subwoofer, and side left
Line Out_2 (black)
4.1, 5.1, 6.1 audio setup: Rear left and right
7.1 audio setup: Rear left, rear right, and side right
Line Out_1 (lime green)
2/2.1 audio setup: Front left and right
FlexiJack (white) for Line In, Microphone, Digital In/Out
The FlexiJack supports three functions. You must select the function in the
Creative Console Launcher. See "Connecting the FlexiJack connector."
To connect the X-Fi sound card to your speakers:
1 Use the audio connection table to connect your audio system to the sound card.
2 Turn on the computer.
3 Plug in and turn on the speaker system power.
After connecting the speaker system to the sound card, follow the steps in "Connecting the
FlexiJack connector" to configure the speaker settings in the Creative Sound Blaster X-Fi
software.