Table of Contents
Advertisement
[ENG] UniPing server solution v4/SMS & UniPing server solution v3, User guide -[USS] Setting Parameters to Default Values (to
[USS] Setting Parameters to Default Values (to the Factory
Settings)
Resetting parameters to the factory settings is necessary in the following cases :
•
A loss of a login and/or password to a web interface of a device;
•
A lack of information about current IP address of a device;
•
In some cases after a device software update.
A procedure of resetting parameters to the factory settings changes all customizable parameters of a device to the
default ones. (IP and MAC addresses, access filters, a user name, a password, etc.).
To reset parameters to default settings, fulfill the next actions sequentially:
•
Turn off a power supply of a device;
•
Press the Reset button (a button Set for a UniPing v3 monitoring unit);
•
Turn on a power supply of a device, continuing to hold Reset button pressed for 15-20 seconds;
•
Release the button. All parameters of a device are set to default settings.
On default, the next parameters of a device are set:
User name: visor
Password: ping
IP address: 192.168.0.100
Subnetwork mask: 255.255.255.0
Gateway: not set
SNMPcommunity: SWITCH
MAC-address: 00 a2 xx xx xx xx
Here xx xx xx xx corresponds to a serial number of a device. Thus, all devices after being manufactured
have unique MAC-addresses.
After resetting parameters to default settings there is a need to do an initial configuration of a device.
[USS] Setting Parameters to Default Values (to the Factory Settings)
the Factory Settings)
–
Advertisement
Table of Contents
