Table of Contents
Advertisement
[USS] Sensors Plugin
It is prohibited to plug sensors and external modules into NetPing devices when a power supply is on!
Configuring a device and receiving notifications from sensors are described in the document
Description».
Sensors of 1-Wire Model Line
Sensors of a 1-Wire model line
into 1W sockets by RJ12 plugs. It is allowed to use extenders and splitters. A maximum loop length of the 1-Wire
network is limited to 50 meters. It is possible to plug up to eight temperature sensors and up to four humidity
sensors to a device simultaneously.
Latest firmware work only with sensors with a 1-Wire interface (THS temperature sensor, HS humidity sensor, etc.).
Outdated firmware versions also supported temperature sensors of TS,
IR
Transceiver IRC-TRv2
An IR transceiver is connected by a four-line wire according to the table below:
Sensor
Flex
Yellow
Labeled wire (red).
Green
Second wire after a labeled
Red
Third wire after a labeled
Black
Fourth wire after a labeled
A sensor is shipped with an inseparable cable with connectors at the ends. A cable length can be extended using
RC-4 sensor cable
extenders, which are consequentially plugged one into another using any wire with a section no
2
less than 0,4 mm
. A maximum loop length is 10 meters from each sensor to a device (a «star» topology).
Sensors
of Dry Contact Type
Dry contact sensors are door opening sensors, buttons and other sensors with a mechanism of work based on
opening/closing a conductor. A sensor is connected with two wires to an IO line of a device according to the table.
An order of plugging wires does not matter.
[ENG] UniPing server solution v4/SMS & UniPing server solution v3, User guide -[USS] Sensors Plugin
(Temperature 1-wire, (THS), 2m and Humidity sensor 1-wire (HS),
Sensor Flex
SCL
SDA
one
+5V
one
GND
one
WT
UniPing server solution v4/SMS, UniPing server solution v3
Terminal Block
«Firmware
2m) are plugged
series as well, using the i2c interface.
[USS] Sensors Plugin
–
Advertisement
Table of Contents
