Table of Contents
Advertisement
NetPing AC/DIN External Sockets
The amount of plugged in
All wires are used to plug a socket into a device except a brown one (a white one). The IO line, where a socket AC/
DIN is connected, needs to be switched to an output mode. When a status of an IO line is a logic level 0, there will be
220V on a socket, a voltage will be turned on. When its status is a logic level 1, a socket will be de-energized, a
voltage off.
Important! The brown wire is not used and must stay unplugged!
Controlling through an IO line:
Sensor Flex
Red
Black
Blue (green)
Controlling through RELAY (NO is normally opened contact, NC is a normally closed contact):
Sensor Flex
Red
Black
Blue (Green)
«+5V» terminal is plugged to a normally opened relay contact (a left terminal in «Relay») by an
When plugging
NetPing AC/DIN
•
RELAY "On" there is no voltage in a socket;
•
RELAY "Off" there is voltage in a socket
A relay with normally closed contacts is used for a load commutation in a NetPing AC/DIN. This means having 220 V
on a socket and a voltage turned on when a control wire is not plugged in.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
[ENG] UniPing server solution v4/SMS & UniPing server solution v3, User guide -[USS] Sensors Plugin
NetPing AC/DIN
sockets is limited by the amount of available IO lines only.
UniPing server solution v4/SMS, UniPing server solution v3 Terminal Block
UniPing server solution v4/SMS, UniPing server solution v3 Terminal Block
Middle contact of a «Relay» terminal
to a relay:
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
+5V
GND
One of IO lines – 1 - 8
+5V
GND
auxiliary wire
2
. Maximum allowable length of a
[USS] Sensors Plugin
–
Advertisement
Table of Contents
