Set Supervisor / User Password - Biostar BVK2A Manual

Chapter2

2.12 Set Supervisor / User Password

Figure 12. Set Supervisor / User Password

CMOS Setup Utility-Copyright (C ) 1984-2000 Award Software
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Enter Password:
Power Management Setup
PnP/PCI Configurations
PC Health Status
Esc : Quit
F10 : Save & Exit Setup
When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. The password you
type now will clear any previously entered password from CMOS memory. You
will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <ESC> to abort the selection and not enter a
password. To disable password, just press <Enter> when you are prompted to
enter password. A message will confirm that you wish to disable the password.
Once the password is disabled, the system will boot and you can enter setup
freely.
Frequency / Clock Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
: Select Item
Change/Set/Disable password
ENTER PASSWORD
2-35
BIOS Setup