Biostar BVK2A Manual page 55

Chapter2
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and if you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial ports.
The Choices: Disabled, Auto, (3F8/IRQ4), (2F8/IRQ3), (3E8/ IRQ4),
UART 2 Mode
This item allows you to determine which Infra Red (IR) function of the onboard
I/O chip, you wish to use.
The Choices: Standard (default), HPSIR, ASKIR.
IR Function Duplex
This item allows you to determine which Infra Red (IR) function of onboard I/O
chip.
The Choices: Half (default), Full.
TX, RX inverting enable
This item allows you to determine the active of Rx, Tx.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O address.
Onboard Parallel Mode
Select an operating mode for the onboard parallel (printer) port. Normal EPP
(Extended Parallel Port) ECP (Extended Capabilities Port) ECP+EPP PC AT
parallel port Bidirectional Port Fast, buffered port Fast, buffered, Bidirectional
Port. Select Normal unless you are certain your hardware and software both
support EPP or ECP mode.
(2E8 / IRQ3).
2-20
BIOS Setup