Set Supervisor/User Password - Biostar M6VCT User Manual

Chapter 2

2.11 Set Supervisor/User Password

Figure 10. Set Supervisor/User Password
CMOS Setup Utility-Copyright (C ) 1984-1999 Award Software
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management Setup
PnP/PCI Configurations
PC Health Status
Esc : Quit F9: Menu in BIOS
F10 : Save & Exit Setup
When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. The password you
type now will clear any previously entered password from CMOS memory. You
will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <ESC> to abort the selection and not enter a
password. To disable password, just press <Enter> when you are prompted to
enter password. A message will confirm that you wish to disable the password.
Once the password is disabled, the system will boot and you can enter setup
freely.
Frequency Control
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Enter Password :
Exit Without Saving
Change / Set / Disable Password
ENTER PASSWORD
2-35
BIOS Setup
: Select Item