Installation Steps - TYAN Tsunami S1846S User Manual

Table of Contents

Advertisement

(2) Hold the motherboard by its edges and do not touch the bottom of
(3) Avoid touching motherboard components, IC chips, connectors,
(4) Avoid touching pins of memory modules and chips.
(5) Place motherboard on a grounded antistatic surface or on the
Having reviewed the precautions above, the next step is to take the mother-
board out of the cardboard box and static bag, hold it by its edges, and place it
on a grounded antistatic surface, component side up. Inspect the board for
damage.
warning
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN DAMAGED!
Press down on any of the socket ICs if it appears that they are not properly
seated (the board should still be on an antistatic mat). Do not touch the bottom
of the board. Remember, don't take any electronic device out of its protective
bag until you are ready to actually install it into the computer case. If you do
not ground yourself, you risk zapping the motherboard or adapter card.
Subsequent problems may not arise immediately because electrostatic dis-
charge damage, unlike physical damage, causes the device to fail over time.
*Power Supply Requirement: ATX Power Supply should be 2.01 compliant.
Standby current must be 750mA or higher (SB5V = 0.75A)

Installation Steps

You are now ready to install your motherboard. The mounting hole pattern of
the Tsunami ATX matches the ATX system board specifications. Your chassis
should be able to accomodate an ATX motherboard and have an ATX power
supply.
1. Set Jumpers
1.
2.
2. Mount Motherboard in Chassis
3.
3. Install Memory
procedure
4. Install CPU & Cooling Fan
5. Connect IDE and Floppy Drives
6. Connect Power Supply
7. Install Add-on Cards
8. Connect PS/2, USB, Serial and Parallel Devices
S1846 Tsunami ATX
the board.
and leads.
antistatic bag.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tsunami s1846Tsunami s1846sla

Table of Contents