Test Mode - Panasonic KX-FP207FX-S Service Manual

KX-FP207FX-S/FP218FX-S

10 Test Mode

The codes listed below can be used to perform simple checks for some of the unit's functions. When complaints are received
from customers, they provide an effective tool for identifying the locations and causes of malfunctions. To do this, you set the
Service mode (Refer to Operation Flow (P.62).) first, then operate the below test items.
Test Mode Type of Mode
MEMORY CLEAR Service Mode
FLASH MEMORY Service Mode
CHECK
DTMF SINGLE TEST Service Mode
MODEM TEST Service Mode
(KX-FP207)
MODEM TEST Service Mode
(KX-FP218)
SCAN CHECK Service Mode
MOTOR TEST Service Mode
LED CHECK Service Mode
LCD CHECK Service Mode
KEY CHECK Service Mode
MEMORY CLEAR Service Mode
(except History data)
VOICE PROMPT Service Mode
CHECK (KX-FP218)
Code
Operation after code
input
"5" "5" "0" Refer to Memory Clear Specification (P.66).
SET
"5" "5" "1" Indicates the version and checks the sum of the FLASH MEMORY.
SET
"5" "5" "2" Outputs the DTMF as single tones. Used to check the frequencies of the individ-
ual DTMF tones. Refer to DTMF Signal Tone Transmit Selection (P.59).
1....ON
2....OFF
"5" "5" "4" Telephone line circuit is connected automatically, output the following signals on
the circuit line.
SET
1) OFF 2) 9600bps
5) 2400bps 6) 300bps 7) 2100Hz
"5" "5" "4" Telephone line circuit is connected automatically, output the following signals on
the circuit line.
SET
1) OFF 2) 14400bps 3)12000bps 4)96V17 5)72V17 6)9600bps
7200bps 8)4800bps 9)2400bps 10)300bps 11)2100Hz 12)1100Hz
"5" "5" "5" Turns on the LEDs of the CIS and operates the read systems.
"5" "5" "6" Rotates the transmission and reception motor to check the operation of the motor.
00: Stop
SET
02: TX
05: Pickup
08: Rx
10: Copy
11: Assist
13: Home position
• Press [STOP] button to quit.
"5" "5" "7" All LEDs above the operation panel board flash on and off, or are illuminated.
"5" "5" "8" Checks the LCD indication.
Illuminates all the dots to check if they are normal.
SET
"5" "6" "1" Checks the button operation.
Indicates the button code on the LCD while the button is pressed. Refer to But-
START (any key)
ton Code Table (P.60).
"7" "1" "0" Refer to Memory Clear Specification (P.66).
SET
"7" "8" "4" You can hear the voice prompt from speaker after pressing .SET. key.
SET
58
Function
3)7200bps 4) 4800bps
8)1100Hz