Scope Of Delivery; Accessories; Intended Use; Technical Description - Dometic BUTTNER MT LB30 Installation And Operating Manual

A
NOTICE! Damage hazard
• Only install the battery in environments with an
ambient temperature of at least 0 °C.
• Avoid deep discharge of the batteries.

Scope of delivery

Quantity Description
1 MT LB 30, MT LB 2412-25 or
MT LB 2412-45
1 Temperature sensor with cable (3 m)
1 Installation and Operating manual

Accessories

Available as accessories (not included in the scope
of delivery):
Designation
Extension cable (5 m) with adapter
for display panel used for remote
control
D+ Active simulator

Intended use

The battery charger (also referred to as charging
booster) is intended to monitor and charge 12 V
house batteries in motor homes from the alternator
while driving.
The charging booster is intended to be used to
charge the following battery types:
• Lead acid batteries
• Lead gel batteries
• Absorbed glass mat (AGM) batteries
• LiFePO4 batteries (14.4 V)
The charging booster is not intended to be used
to charge other types of batteries (e.g. NiCd,
NiMH, etc.).
The charging booster is suitable for:
• Installation in motor homes
• Stationary or mobile use
• Indoor use
The charging booster is not suitable for:
• Mains operation
• Outdoor use
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
• Incorrect maintenance or use of spare parts
Ref. no.
• Alterations to the product without express per-
9620000171
(MT 02005)
• Use for purposes other than those described in
9620000336
Dometic reserves the right to change product
(MT02159)
appearance and product specifications.

Technical description

General description
MT LB 30: The device charges with 30 A while
driving. The charging power can be limited to
25 A.
MT LB 2412-25: The device charges with 25 A
while driving. The charging booster is suitable for
vehicles equipped with a 24 V starting battery cir-
cuit. Galvanic isolation between the inputs (IN) and
outputs (OUT) ensures absolute separation of the
battery circuits.
MT LB 2412-45: The device charges with 45 A
while driving. The charging booster is suitable for
vehicles equipped with a 24 V starting battery cir-
cuit. Galvanic isolation between the inputs (IN) and
outputs (OUT) ensures absolute separation of the
battery circuits.
4445103799
excess voltage
other than original spare parts provided by the
manufacturer
mission from the manufacturer
this manual
15