To Set At A Desired Speed; To Deactivate; To Resume Speed; To Vary The Speed Setting - Chrysler 2007 Pacifica Instruction Manual

To Set At A Desired Speed:

When the vehicle has reached the desired speed, press
and release the "SET" button. Release the accelerator and
the vehicle will operate at the selected speed. The
CRUISE SET indicator located near the instrument clus-
ter odometer will illuminate showing the electronic
speed control is set.
NOTE: While in the AutoStick mode, Speed Control will
only function in third or fourth gear.

To Deactivate:

A soft tap on the brake pedal, pushing the "CANCEL"
button or normal braking while slowing the vehicle will
deactivate the speed control without erasing the memory.
Pushing the "ON/OFF" button to the OFF position or
turning off the ignition erases the speed memory.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 151

To Resume Speed:

To resume a previously set speed, push and release the
"ACCEL/RESUME" button. Resume can be used at any
speed above 25 mph (40 km/h).

To Vary the Speed Setting:

When the speed control is set, speed can be increased by
pressing and holding the "ACCEL/RESUME" button.
When the button is released, a new set speed will be
established.
Tapping the "ACCEL/RESUME" button once will result
in a 2 mph (3 km/h) speed increase. Each time the button
is tapped, speed increases so that tapping the button
three times will increase speed by 6 mph (10 km/h), etc.
To decrease speed while speed control is set, press and
hold the "COAST" button. Release the button when the
desired speed is reached, and the new speed will be set.
3