Table of Contents
Advertisement
Mounting the base station on a wall
1.
Unscrew the foot stand, and remove it from the base station.
2. Install two mounting screws on the wall. Choose screws with heads larger than 5 mm
(3/16 inch) in diameter (1 cm / 3/8 inch diameter maximum). The screw centers should be
60 cm (2 3/8 inches) apart vertically or horizontally.Tighten screws until only 3 mm (1/8
inch) of the screws are exposed.
3. Connect the Ethernet cable and
power as described in "Base Station
Installation" on page 14-15.
4. Place the base station over the
mounting screws.
16
Advertisement
Table of Contents
