Table of Contents
Advertisement
USB2: Front panel USB headers
The mainboard has a USB port installed on the rear edge I/O port array. Some
computer cases have a special module that mounts USB ports at the front of
the case.
Pin
Signal Name
1
VCC (+5V)
3
USBDT2-
5
USBDT2+
7
GND
9
EMPTY
WOL1/WOM1: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with the card to plug
into the mainboard WOL1 connector. This enables the Wake On LAN (WOL1)
feature. When your system is in a power-saving mode, any LAN signal auto-
matically resumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin
Signal Name
1
5VSB
2
GROUND
3
SENSE
If you have installed a modem, use the cable provided with the m odem to plug
into the mainboard WOM1 connector. This enables the Wake On Modem
(WOM1) feature. When your system is in a power-saving mode, any modem
signal automatically resumes the system. You must enable this item using the
Power Management page of the Setup Utility. See Chapter 3 for more infor-
mation.
SIR1: Serial infrared port
The mainboard supports a Serial Infrared (SIR) data port. Infrared ports allow
the wireless exchange of information between your computer and similarly
equipped devices such as printers, laptops, Personal Digital Assistants
(PDAs), and other computers.
Pin
Signal Name
1
NC
3
+5V
5
IRTX
J4: Sleep Switch
This header is connected to the sleep button for suspending the computer's
activity if pushing the button. Or, the computer is automatically suspended
after passing a period of time.
Pin
Signal Name
2
VCC (+5V)
4
USBDT3-
6
USBDT3+
8
GND
10
OC# (over current detect)
Pin
Signal Name
2
KEY
4
GROUND
6
IRRX
21
Advertisement
Table of Contents
