Supermicro SuperServer 1029UX-LL1-S16 User Manual page 56

SuperServer 1029UX-LL1-S16/LL2-S16/LL3-S16 User's Manual
I C Bus for VRM
2
Jumper JVRM1 allows the BMC or the PCH to access CPU and memory VRM controllers.
See the table below for jumper settings.
Watch Dog
JWD controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for
the application that hangs. Watch Dog must also be enabled in BIOS.
The default setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application software
to disable it.
VRM
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC (Normal)
Pins 2-3 PCH
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
56