Advertisement
6
4 x 4
1. Insert the Shelf Support (4)
into the pre-drill holes in
Side Panel (B) and Right Side
Panel
(C).
2. Place the Inner Shelf Panel (E)
onto the Shelf Support (4).
7
5 x 8
5
5
L
L
I
8
5 x 16
I
E
B
TIP: To adjust the vertical gaps between the doors, loosen or tighten the screw shown in Diagram C. To adjust
the door so it is flush with the trim panels, loosen the screw in Diagram B. Adjust the hinge until the door is
flush, then retighten the screw.
B
Left
4
1. Attach Hinges (L) to Door Panel (I) with Screw (5).
2. Attach Metal Handle (K) to each door with Bolt (11).
11 x 2
5
5
5
L
×2
1. Attach Door Panel (I) onto the Left Side Panel (B) and Right Side Panel (C)
with Screw (5).
Note: The back edge of the door should be in line with the inside edge of
16 x 2
the trim panel. Attach Hinge (L) with Screw (5) only using the back upper
and back lower holes in the hinge at this time. Make sure the screws are at
the top of the hole opening. Once both Hinges (L) are attached, slightly
loosen the screws and adjust the door so it is in the middle of the opening
Fully tighten the screws. Insert screws (5) into the front holes of Hinge (L)
and fully tighten.
2. Apply Sticker (16) to the front edge of Inner Shelf Panel (E).
5
I
C
16
5
C
4
4
4
E
5
16
Page 7 of 8
4
11
I
×2
K
a
b
c
d
11
K
Advertisement
