Advertisement
F3.1=2, 4800 baud rate
F3.1=3, 9600 baud rate
d. Press [PT] button, indicator displays "F3.2
F3.2=0, command mode
F3.2=1, continuous transmit mode
Press [Fn] button to choose parameters
e. Press [PT] button, indicator displays "F3.3
XXX means the address of this indicator when multi-indicators are
communicated together, press [0] or [Tare] to amend present address.
f. Press [PT] button, indicator displays "F3.4 X"
0: Transmit the weight data
1: Transmit the number of division of the weight data
Choose "1" when the weight data includes decimal or the weight is bigger than
32767kg.
g. Press [Tare] button for many times, and press [PT] button to quit out when
indicator displays "
Please contact KELI if you want to get the protocol of multi-indicator's
communication. KELI also can make custom-built protocol per customer's
request.
9.2. Choose assemble ways
Serial interface receive data by two ways: RS232 and RS485, and change wire
position on circuitry board and choose one.
Open transducer backboard, pull out circuitry board slightly. In the middle of board
there is a three wire pin marked J501, sideward number is the serial number of pin.
Short block insert on 1-2 feet to choose RS232 to receive data, and insert on 2-3
feet to choose RS485 to receive data.
10. Power on self test information
Turn on the indicator after all the system be connected, firstly indicator displays
number "0"－"9", and then displays analog output mode.
0-20 stands for 0-20mA output
4-20 stands for 4-20mA output
0-5 stands for 0-5V output
0-10 stands for 0-10 output
When serial interface chooses continuous transmit data, it can displays pre-set
baud rate. Finally indicator displays "―――――――", to catch zero, if weight data
is unstable or no connection to load cell, indicator will keep this situation for a long
time.
www.kelichina.com
X"
XXX"
Page 15 of 17
Advertisement
