Advertisement
Analog output can choose one of the following modes: 0－20mA、4-20mA、0-5V
and 0-10V. Choose according to the following steps:
a.
Press [Fn] and [ 0] buttons simultaneously, indicator displays "
b.
Press [Fn] button for three times continuously, indicator displays "
c.
Press [ PT ] button, indicator displays "
choose parameter.
F4.1=0, current output 0－20mA;
F4.1=1, current output 4－20mA;
F4.1=2, voltage output 0-5V;
F4.1=3, voltage output 0－10V;
d.
Press [Tare] button, when indicator displays "
quit out. Turn it on again; analog output will work as chosen mode.
6.2. Choose corresponding weight range of analog output
Weight range of analog output can be from zero to maximum weight value, or any
section between zero and maximum value. Set-up as below:
a. Press [Fn] and [ 0] buttons simultaneously, indicator displays "
b. Press [Fn] button for three times continuously, indicator displays "
c. Press [PT] button for two times continuously, indicator "
[Fn] button to choose parameter.
F4.2=0, weight transducing range is from zero to maximum value. When it is
zero, it corresponds to bottom of analog output. When it is maximum weight, it
corresponds to top of analog output.
F4.2=1, weight transducing range is any section between zero and maximum
value.
d. When F4.2=1, press [PT] button, indicator displays "AL XXXXX"，and set
corresponding value of bottom of analog output, press [Fn] and [0] buttons to
change value. Value can be any point between zero and maximum weight.
e. Press [PT] button, indicator displays "AH XXXXX"， and set corresponding
value of top of analog output, press [Fn] and [0] buttons to change value. Value
can be any point between zero and maximum weight, but it must be more than
AL.
f. Press [PT] button for one time, and then press [Fn] button for one time, when
indicator displays "
www.kelichina.com
" press [PT] button to quit out. Turn it on again; analog
"
"，press [ Fn ] button to
" then press [PT] button to
"
"
Page 11 of 17
"
", press
Advertisement
