Advertisement
Note: when uV of each division is less than 0.6 uV, indicator will show "E4",
then press [ Tare ] button, it returns to the previous step. Press [ PT ] button, the
calibrated result can be accepted. In other words, uV of each division is less
than 0.6nV, indicator still work correctly.
k. Press [ PT ] button, indicator displays "
pole is extinguished gradually. During this time the reading is unstable and the
light pole comes back to the full-bright state. After light pole fully extinguished,
indicator will turn to next step automatically.
l. The value of loaded poise should be inputted when indicator displays maximum
weighing value XXXXX. Press [ Fn ] button, position of glittering can be chosen
and press [→0←] button, value of glittering bits can be amended.
m. Press [ PT ] button, indicator displays "
can switch to display "
[ PT ] button, it means accepting and saving the calibrated result. When it
displays "
available only this time, when turn on the transducer again, it adopts the
previous calibrated data. Until now, calibration is finished.
Tips:
If the zero drift of load cell exceeds the range of zero set-ups when power on,
Zero can be calibrated again as calibration steps. When it is step 7, press
[ Tare ] button for many times, and when indicator displays "
button to quit out.
Notice: incorrect operation – such as press [ PT ] button when displaying
"
", it will turn into capacity-proofread step. So you must be careful
when calibrating zero separately.
6. Choice and adjustment of analog output modes
Calibrating head must be inserted and then the calibration can be operated. It is
only available when indicator possesses analog output module.
6.1. Choose and adjustment of output mode
www.kelichina.com
". When it displays "
", press [ PT ] button, it means the calibrated result is
", meanwhile the light
", then press [ Fn ] button, it
", press [ PT ]
", press
Page 10 of 17
Advertisement
