ACR Electronics RCL-100 LED Product Support Manual page 5

coax cable from the Master Controller can be routed to this location.
Generally, the Point Pad™ should be mounted in a protected area.
Note that the Point Pad™ is water resistant, not waterproof.
Install the surface mount Point Pad™ by drilling 3 holes in the
dashboard location using the Point Pad™ Surface Mount Template
supplied with the searchlight (Part numbers 1950, 1951, & 1953).
Mount the Point Pad™ to the dashboard using the gasket, washers
and nuts supplied. Use a sealant around the bolt holes to protect from
moisture intrusion.
When the flush mount option is selected, cut a rectangular hole in the
dashboard location using the Point Pad™ Flush Mount Template
supplied with the searchlight (Part numbers 1950, 1951, & 1953). Use
the gasket, washers, nuts, and the two U-Clamps provided to secure
the Point Pad™. Use a sealant around the cut out to protect from
moisture intrusion.
Connecting to the Master Controller
The Point Pad™ communicates with the Master Controller via
standard television type RG-59 coaxial cable and F-type connectors
(supplied with the light). The connector on the back of the Point
Pad™ is located in the center of the panel for ease of installation.
After the coax cable has been routed and the "F" connectors
attached, screw the "F" connectors to the Master Controller and the
Point Pad™.
Additional Point Pads™ (up to three Pads) may be used with one (1)
Master Controller. A standard RG-59 television type "splitter" is used
for each additional Point Pad (see Figure 1). Limit the total length of
all coax cable used to 300 feet.
The URP-102 Point Pad™ is backwards compatible with all RCL-
100/50 Searchlights.
NOTE: The URP-102 Point Pad™ should not be used with the first
generation URC-100 Master Controllers.
Please be aware of the following to ensure the searchlight
works correctly after installation.
Vessel power to the Master Controller is connected as follows:
Y1-03-0321C 5