Section 1 - General; Section 2 - Searchlight - ACR Electronics RCL-100 LED Product Support Manual

Remote control searchlight system
Table of Contents

Advertisement

SECTION 1 - GENERAL

The RCL-100 LED was specially designed for mariners who require a
high intensity remote controlled searchlight that can stand up to the
tough marine environment.
The RCL-100 LED Searchlight System contains a narrow beam
searchlight that produces 220,000 peak candle power by combining a
9 LED array with unique optical quality reflectors.
The Searchlight (part numbers 1950, 1951 & 1953) can be electrically
operated by remote control from the pilot area of the vessel using the
URP-102 Point Pad™, URC-103 Master Controller, and interconnect
cable supplied with the RCL-100 LED. Searchlights equipped with the
URC-103 Master Controller have ACR's unique XRCiZ™ (exercise)
feature. The XRCiZ™ feature routinely rotates the searchlight to keep
the motors and drive mechanism freely running. The wired kit
(Searchlight part number 1951) is supplied with the wired URP-102
Point Pad™ and the wired URC-103 Master Controller. The mobile kit
(Searchlight part number 1953) is supplied with the wired URP-102
Point Pad™, the wired URC-103 Master Controller, and the Wi-Fi
Remote Control Module.

SECTION 2 - SEARCHLIGHT

The sleek design and modern construction of the Searchlight body
makes it attractive for recreational and commercial vessels. The
Searchlight is totally enclosed and is made of rugged aluminum alloy.
It is water resistant if properly installed.
Mounting of the Searchlight
Make sure the mounting area is clean and dry. The Searchlight can
be mounted where desired, using appropriate length 3/16" diameter,
stainless steel fasteners. Four (4) nylon shoulder washers are
supplied with the RCL-100 LED Searchlight. The nylon washers
prevent a galvanic reaction between the mounting hardware and the
base of the Searchlight. Be sure these washers have been inserted in
the base mounting holes and that the mounting base gasket is
securely in place before bolting down. It is recommended that a thin
coating of marine grade silicone rubber be applied to the top and
bottom outside edges of the gasket to improve the water resistance of
Y1-03-0321C
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

1950195119521953

Table of Contents