Table of Contents
Advertisement
the unit. When mounting, be sure that the Searchlight is able to rotate
360° without hitting any obstructions. For the drilling hole pattern,
refer to the Searchlight Mounting Template supplied with the RCL-
100 LED searchlight.
DURING INSTALLATION OR OTHERWISE, DO NOT TURN
THE LIGHT BY HAND, OR FORCE IT TO TURN MANUALLY
AT ANY TIME. THE PLANET GEARS WILL BE STRIPPED.
CAUTION: Do not mount the searchlight upside down. Moisture
could enter the light through the unprotected neck section.
NOTE: The Searchlight should be left uncovered if the XRCiZ
(exercise) feature is enabled.
SECTION 3 - URP-102 POINT PAD™
Case Options
The URP-102 Point Pad™ is supplied as a surface mount unit (see
Figure 3). A flush mount option is provided (see Figure 4). To switch
mounting options, unscrew the six (6) screws on the unit's back plate
and remove the front cover. Fit the Point Pad™ with the flush mount
cover, replace the back plate, and screw the unit back together.
Mounting of the Point Pad
Both the surface mount and flush mount options require access to the
backside of the mounting location. Make sure there are no
obstructions behind the area where the switch is to be located (e.g.
bulkheads, wires, plumbing, or hardware). Check in advance that the
Y1-03-0321C
4
Advertisement
Table of Contents
