Switching Temporarily To Tone Dialing - Canon imageCLASS MF3240 Series Advanced Manual

Advanced Fax
Features 1
Advanced Copy
Features
2
System Monitor
3
Reports and Lists
4
Troubleshooting
5
Appendix
6
Table of Contents
Index
6.
Use [ ] or [ ] to select the number of
redials the machine will make, then press
[OK].
Ex.
R E D I A L T I M E S
2 T I M E S
You can also enter values with the numeric keys.
NOTE
Reagrdless of the number you entered, the machine makes only one
redialing attempt if it does not detect a busy signal.
7.
Use [ ] or [ ] to select the time (in
minutes) between redials, then press [OK].
Ex.
R E D I A L I N T E R V A L
2 M I N .
You can also enter values with the numeric keys.
8.
Press [Stop/Reset] to return to standby
mode.
■

Switching Temporarily to Tone Dialing

If your machine is set for pulse dialing, use the procedure below
to switch to tone dialing to use information services (e.g., banks,
airline reservations, and hotel reservations).
NOTE
To talk to the other party, you will need to connect a telephone to the
machine.
Back Previous
1.
Press [FAX].
2.
Press [Hook].
NOTE
Make sure to confirm the dial tone before entering a fax number.
If you enter the number before the dial tone can be heard, the call
may not be connected, or the wrong number may be dialed.
3.
Use the numeric keys to dial the required
information service.
4.
When the recorded message of the
information service answers, press [Tone] to
switch to tone dialing.
5.
Use the numeric keys to enter the numbers
requested by the information service.
6.
If you want to receive faxes, press [Start].
7.
When finished, press [Hook] to disconnect
the call.
Tone dialing is canceled when you disconnect the call.
TOP
Next
1-4