Canon PIXMA MP450 User Manual page 112

Error message on camera
Waste tank (ink absorber) full
No ink
Printer error
*1
To resume printing, you can press [OK] on the machine instead of selecting Continue.
110
Troubleshooting
This error message indicates that the waste ink absorber is nearly full.
The machine has a built-in waste ink absorber to hold the ink used during
FINE Cartridge cleaning, for example.
You can continue printing by selecting Continue
camera.
However, because printing is disabled once the waste ink absorber
becomes completely full and until the waste ink absorber is replaced, you
are recommended to contact a Canon service representative as soon as
possible.
Prepare a new FINE Cartridge.
*1
Select Continue in the display on your camera to resume printing.
Replace the FINE Cartridge and close the Scanning Unit.
If printing is in progress and you want to continue printing, press [OK]
with the FINE Cartridge installed.
Then printing can continue under the ink out condition by selecting
*1
Continue on the display on your camera.
Replace the empty FINE Cartridge immediately after this printout. The
machine may be damaged if printing is continued under the ink out
condition.
The FINE Cartridge may not be the compatible with this machine. Install
the appropriate FINE Cartridge.
An error requiring servicing might have occurred.
Disconnect the cable between the machine and the camera, turn OFF the
machine, and unplug the power cord of the machine from the power
supply. After a while, plug the power cord of the machine back in, turn ON
the machine, and then reconnect the camera to the machine. If the same
error occurs, contact a Canon service representative.
Action
*1
on the display on your
Chapter 11