An Error Message Appears On The Screen - Canon PIXMA iP2000 Quick Start Manual

An Error Message Appears on the Screen

Problem Possible Cause
Printer not ready
Error Writing /
Output to USBnnn or
MPUSBPRNnn
Paper is not loaded Load paper and press the R R ESUME/CANCEL button.
Faulty connection
Printer port error
Printer port settings
and printer
interface do not
match
Printer driver is not
installed properly
Printer not ready
"Error No.: 300"
Printer not properly
connected
Your printer name is
not displayed in the
Printer List of
Printer Setup Utility
(or P P rint Center).
The POWER lamp will flash green when the printer is warming up or when a print
job is being sent to the printer. It will glow a steady (non-flashing) green when it
is ready for use or when the print job is completed.
Ensure that the printer cable is securely connected to the computer.
Note If you are using switching hub or other device, disconnect the
printer and reconnect it directly to the computer and try printing
again.
If successful, the problem may have been with the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
Verify the printer port status.
Double-click U U niversal Serial Bus (USB) controllers on the D D evice Manager
dialog box, then double-click C C anon PIXMA iP2000 to see the status.
Refer to the User's Guide for instructions on how to verify the status.
Ensure that the destination Printer Port is set to MPUSBPRNnn (C C anon PIXMA
iP2000) or USBnnn (C C anon PIXMA iP2000) (Where nn represents a number).
If the settings are not correct, follow the procedures described in the
Instructions and reinstall the printer driver.
User's Guide
Refer to the for instructions on how to verify status and the correct
action to take.
Uninstall then reinstall the printer driver.
1. Click S S tart, and select A A ll Programs (or P P rograms), C C anon PIXMA iP2000, and
Uninstall.
2. Follow the on-screen instructions to uninstall driver.
3. Follow the procedures described in the
the printer driver.
If the P P OWER lamp is off, turn the printer on.
If the P P OWER lamp is flashing green, the printer is initializing. Wait until the
POWER lamp stops flashing.
Ensure that the printer is securely connected to the computer.
Note If you are using switching hub or other device, disconnect the
printer and reconnect it directly to the computer and try printing
again.
If successful, the problem may have been with the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
1. Select A A pplications from the G G o menu.
2. Double-click the P P rinter Setup Utility icon in the U U tilities folder.
If you are using the OS other than Mac OS X v.10.3, double-click the P P rint
Center icon.
3. Ensure that i i P2000 is displayed in the P P rinter List.
If i i P2000 is not displayed in the P P rinter List, reinstall the printer driver.
Note If the problem persists, delete all unnecessary documents
from the Extensions and Control Panels folder.
Troubleshooting
Try This
Easy Setup Instructions
Easy Setup
and reinstall
69