•
Power saving (p. 36) on the camera is temporarily disabled during image
transfer.
•
Choosing
connection will be restored after you choose another shooting mode or enter
Playback mode, the camera may transfer any movies made in
Checking Connection Information
Check the access point SSID used by the Eye-Fi card or the connection
status, as needed.
Disabling Eye-Fi Transfer
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
•
[Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camera
with its write-protect tab in the unlocked position. For this reason, you
cannot change settings for an inserted Eye-Fi card if the write-protect
tab is in the locked position.
mode will interrupt the Eye-Fi connection. Although the Eye-Fi
Press the n button, choose [Eye-Fi
Settings] on the 3 tab, and then press the
m button.
Choose [Connection info], and then press the
m button.
The connection information screen is
displayed.
Choose [Disable] in [Eye-Fi trans.].
Press the n button, choose [Eye-Fi
Settings] on the 3 tab, and then press the
m button.
Choose [Eye-Fi trans.], and then choose
[Disable].
Using an Eye-Fi Card
mode again.
213