Canon imagePROGRAF iPF8300S User Manual page 14

8
Pull out the paper so it is even on both
sides and insert it into the feed slot (b),
and feed it until it contacts the paper
retainer (a).
10
While holding the leading edge of the
paper roll, raise the release lever.
• Be sure to perform steps 0 and . If paper cannot feed straight or becomes curled, it may rub
against the print head or be jammed.
• Do not pull paper in an attempt to force it to align with the paper alignment line (b). Doing so may
cause the paper to not feed straight.
13
The screen for selecting the paper type
is shown on the display screen. Press ▲
or ▼ to select the type of paper loaded in
the printer.
Select Coated Paper and then press OK.
Then from the menu that appears, select
HW Coated and then press OK.
• If Paper loaded crooked. appears on
the display screen, refer to steps 0 and
MEMO
 to reload the roll of paper.
If the error occurs again after you reload
the paper, remove the roll holder from
the printer and check to make sure that
the roll of paper is in close contact with
the roll holder flange as described in
step 5.
• After you have finished setting up the printer and installing the software and electronic manuals, we recommend performing color calibration. Color
calibration compensates for changes in color from individual variation and aged deterioration of the printer, ensuring better color consistency.
MEMO
Perform color calibration using the provided Sample Paper, which is compatible with this process. For information on other compatible paper, refer
to the Paper Reference Guide.
During color calibration, on the control panel's display screen, open
The process of color calibration takes about 3 minutes.
• If you use the color calibration for color adjustment, it is useful to set the function to notify the execution period (Prompt Execution). For details of
the function, refer to "Using Color Calibration for Color Adjustment" in User's Guide.
The paper feeds automatically until it contacts the
paper retainer.
• Take care to avoid soiling the printing
surface when removing rolls of paper. A
soiled printing surface can affect printing
quality.
• Remove all wrinkles and curls from the
paper, if any, before loading it.
• When loading paper, make sure there is no
gap between the right side of the roll and
the roll holder.
11
Holding the leading edge of the paper with
both hands, gently pull it to the ejection
guide (a) as you ensure that the left and
right sides remain even and that the right
edge of the paper remains parallel with
the orange paper alignment line (b). Next,
lower the release lever.
a
14
Printhead position adjustment starts
automatically.
Adjusting the position of the printhead
takes about 9 minutes.
When printhead adjustment is finished,
Ready appears on the display screen.
Printer setup is now complete.
• To enhance printing quality when
printing fine lines/text or photos at high
precision, see "Enhancing Printing
Quality" in the User's Guide.
(settings/adj. tab) and select Adjust Printer - Calibration - Auto Adjust.
4
9
Lower the ejection guide.
Lower the ejection guide carefully, taking
care that the ejection supports (a) do not
touch the paper.
12
Close the top cover.
b
After a roll of paper is loaded, the display
screen automatically display a paper type
selection menu and the printer beeps.