Page 1
UGP 3 SM TOP MOUNT CONTROL PANEL THERMOCOUPLE REPLACEMENT INSTRUCTIONS Models (SM) USA and Canada WARNING: Installation of all gas components must be done by a licensed gas technician. Improper installation, adjustment, alteration, service, maintenance can cause injury or property damage.
Page 2
UNIQUE UGP-3 SM Thermocouple Part # UGP-DL08502311 Tools required 3. Use the end of the screwdriver and tap the burner out of the bracket Phillips’s screwdriver/drill – removing top plate, securing clips, burner, and burner cover. 11 mm wrench – remove the thermocouple from the bracket.
Page 3
6. Begin removing the top panel/plate to access 9. Cut ties and release from clip to discard old the thermocouple and gas valve. thermocouple. Remove Phillip’s screw from each corner and then slide the top off towards the back to access the 10.
Page 4
12. Run thermocouple back through clip and 15. Now that the thermocouple is securely tighten. fastened to the burner. Mount the burner bracket back on the burner assembly using Phillips’s screwdriver. Run thermocouple back through clip. 16. Replace burner cover. 13.