Sealey ADT200 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instruction footwear
manual
1. SAFETY
‰
WARNING! Ensure all preliminary checks are carefully carried out before using the cradle and trolley jack.
9
Immediately repair or replace damaged or missing parts (use an authorised service agent).
9
Ensure use of genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
‰
WARNING! Follow all of the safety instructions issued with the trolley jack.
8
DO NOT exceed the rated capacity of the cradle or jack, whichever is the lower, see Specification.
‰
WARNING! Ensure load is placed level and centrally on cradle and is fixed in place before attempting to lift, lower, or transport.
9
Always use support chain supplied to stabilise and secure the load to the cradle.
8
DO NOT substitute an inferior form of restraint for the support chain.
9
Care should be taken when using the cradle and trolley jack in conjunction with a vehicle lift, to ensure that the vehicle is not lowered
whilst the jack is in position underneath the vehicle.
8
DO NOT move the jack, with or without a load, with the cradle in the raised position.
8
DO NOT use the cradle for any purpose other than for vehicle transmissions.
▲
DANGER! DO NOT use on tarmacadam, or any other soft surface, as the jack may sink or topple. Serious personal or fatal injury may
result.
9
Keep all unauthorised persons away from the area during lifting and lowering and when in transit.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and contain and/or tie back long hair.
9
Ensure the jack is fully lowered and is clean, dry, and oil free before attempting to transport the jack with or without a load.
9
Diligence is required in ensuring that the operation is continually monitored until completed.
8
DO NOT allow untrained persons to operate the jack.
8
DO NOT transport the jack, with or without a load, with the saddle in the raised position.
8
DO NOT operate the jack when you are tired, under the influence of alcohol, drugs or intoxicating medication.
9
Before storing, ensure cradle is clean and free of grease and oil. Store in a safe, dry, childproof location.
2. INTRODUCTION
Fully adjustable saddle with forward, backward and side-to-side tilt. Suitable for jacks with a 31-33mm saddle spigot pin.
Note: When using this cradle, the maximum capacity of the jack and saddle combination will be limited to the lowest specified capacity in the
combination e.g. 3000CXD and ADT200 - maximum capacity will be 200kg.
3. SPECIFICATION
Model No: ................................................................. ADT200
Capacity: ...................................................................... 200kg
Compatibility: ..........................................................3000CXD
© Jack Sealey Limited
200KG TRANSMISSION CRADLE
ADT200
MODEL NO:
Original Language Version ADT200 Issue:2 (H,3,F) 15/03/22