Download Print this page
Sealey VS3847 Quick Start Manual

Sealey VS3847 Quick Start Manual

Suspension strut support

Advertisement

Quick Links

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
protection
instructions
1. Safety
WarninG! Wear approved eye protection. Wear appropriate Personal Protective equipment. A full range of Personal
Protective equipment is available from your Sealey dealer.
WarninG! ensure that Health & Safety, local Authority Regulations and general workshop practice Regulations are adhered to
when using tools.
Do not use tools if damaged.
8
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
8
ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9
Wear suitable clothing to avoid snagging. Do not wear jewellery. Tie back long hair.
9
Account for all tools, parts and components being used. Do not leave these in or near the engine.
9
Return tools to suitable storage after use.
9
These Instructions are provided as a guide only.
8
Always refer to the vehicle manufactures' service instructions or a proprietary manual to establish the correct procedure and data.
9
WarninG! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The
operator/ user must apply caution and common sense (good practical sense).
note: For stability the VS3847 must only be used in conjunction with a transmission jack with a minimum base size of 560mm x
570mm and a ram size of 30mm diameter.
2. Specification
Model no. .................................................................. VS3847
Transmission jack ram size maximum ....................... Ø30mm
Transmission jack base size minimum ........560mm x 570mm
3. operation
3.1.
Fit the VS3847 fully onto the transmission jack ram and finger tighten the butterfly screws provided (fig.2).
3.2.
Remove the hex bolts and the closing plate, fit the VS3847 around the suspension leg beneath the lower spring cup (fig.2).
3.3.
Refit the closing plate, refit and fully tighten the hex bolts (fig.1).
3.4.
Raise the transmission jack to support the suspension strut.
3.5.
Remove the support by reversing the above operations.
fig.1
© Jack Sealey limited
SuSpenSion Strut Support
Model no:
Wear protective
Wear safety
gloves
footwear
introDuction
Original Language Version
VS3847
Wear protective
clothing
fig.2
VS3847 Issue 1 31/10/19

Advertisement

loading

Summary of Contents for Sealey VS3847

  • Page 1 ‰ operator/ user must apply caution and common sense (good practical sense). note: For stability the VS3847 must only be used in conjunction with a transmission jack with a minimum base size of 560mm x introDuction 570mm and a ram size of 30mm diameter.
  • Page 2 It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. important: no liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business park, Bury St edmunds, Suffolk. ip32 7ar 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk...