Sealey SSG1P/3.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Refer to
instruction
manual
1. SAFETY
Familiarise yourself with the application, limitations and potential hazards peculiar to the spray gun.
9
WARNING! Disconnect the spray gun from the air supply before changing accessories, servicing or
‰
performing any maintenance.
Maintain the spray gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous
9
and will invalidate the warranty.
Keep the spray gun clean for best and safest performance.
9
Ensure that the compressed air system can supply the spray gun air consumption (7-12cfm).
9
Wear approved safety respiratory protection and safety eye goggles.
9
If spraying isocyanate based finisher, wear approved respirator/clean air breathing apparatus and
9
protect skin with latex gloves and an impervious hooded coverall.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and tie back long hair.
9
Locate the spray gun in a suitable work area. Keep area clean and tidy and free from unrelated materials
9
and ensure that there is adequate ventilation and lighting.
Keep children and unauthorised persons away from the work area.
9
When not in use, ensure that the air supply is turned off.
9
Avoid unintentional operation of spray gun.
9
DO NOT point spray gun at yourself, other persons or animals.
8
DO NOT direct air from the air hose at yourself, other persons or animals.
8
DO NOT carry the spray gun by the hose, or pull the hose from the air supply.
8
DO NOT exceed the maximum air pressure of 78psi.
8
DO NOT use the spray gun for any purpose other than that for which it is designed.
8
DO NOT allow untrained persons to operate the spray gun.
8
DO NOT get the spray gun wet or use in damp or wet locations or in areas where there is condensation.
8
DO NOT operate the spray gun if any parts are missing or damaged as this may cause failure and/or personal injury.
8
When not in use, disconnect the spray gun from the air supply, clean thoroughly and store safely.
9
2. INTRODUCTION
Pressure pot suitable for use with Model No. SSG1P Pressure Pot Spray Gun.
3. SPECIFICATION
Model No.: ......................................................... SSG1P/3.V3
Description: ...................................................2L Pressure Pot
4. ASSEMBLY
4.1. Connect the air and paint hoses in the following manner.
a: Blue air hose from pressure regulator to gun handle.
b: Clear hose from Pot paint outlet to inlet on underside of nozzle on gun.
4.2. Initially screw parts hand tight to avoid cross-threading. If a part cannot easily be turned by hand, check that you have the correct part, or
unscrew, realign and try again. DO NOT use excessive force when assembling.
5. CLEANING/MAINTENANCE
WARNING! Disconnect from the air supply before attempting any maintenance or cleaning.
‰
5.1. When finished spraying, wipe the outside of the pot and fittings with a dampened solvent rag.
© Jack Sealey Limited
2L PRESSURE POT FOR SSG1P
SSG1P/3.V3
MODEL NO:
Original Language Version
SSG1P-3.V3 Issue 1 11/10/21