Main Board - Sw2; Figure 25: Sw2 Switch Location; Table 23: Evm Switches - Mistral OMAP35 Series Hardware User's Manual

OMAP35x Evaluation Module
S3
S4 to S18
SW1

3.5.10 Main Board - SW2

The SW2 switch is a 2-position jumper located on the topside of the board and
is used to select the source of the input Power as either external Power adaptor
or Battery supply. The image of this switch is shown in the figure below.
Function SW2 Switch Position
Vdc_In To connect an external 5V power supply, select
(Default) the switch position to DC (refer the label on
the EVM main board).
VBAT_In To connect Battery, select the switch position
to Batt (Pin 1).
MOM Main board
MOM Main board
POS Processor Module
Table 23:
Figure 25:
Power ON / OFF
15 - User Functional Keys
Mux control
EVM Switches
SW2 Switch Location
Description
Main Supply (DC Wall Supply)
will be enabled.
Battery will be enabled.
57
Hardware User Guide
DC/Battery
On/Off Switch