Power Module Connector; Switches; Figure 24: Power Module Board-To-Board Connector - Mistral OMAP35 Series Hardware User's Manual

3.5.8 Power Module Connector

P10 P15 & J21 board-to-board connector is used to bring out the entire Power
Module signal to main board. Power module is a plug-in option module that
will plug in to this connector. It is a 66 pin constructed as 33 pin in to 2 row
connector of 3 numbers is used. Refer schematic section for signal and pin out
details for this connector.
Figure 24:

3.5.9 Switches:

The list of switches on OMAP 35x EVM is given below
Switches
SW2
SW4
S1
S2
P15
J21
P10
Power Module board-to-board connector
Type Location
POS Main board
POS Main board
MOM Main board
MOM Main board
Function
Battery or DC input selection
SYSBOOT configuration
Warm Reset
OMAP EVM Reset
56
Hardware User Guide